The disk light on the computer case rarely flashes. The disk is under very light load, but I can't make it totally idle since it is the / filesystem disk (eg rootfs). I first noticed the problem when after 24 hrs the next scheduled test was aborted because the previous test didn't complete. I have observed this with both scheduled tests and tests started from the command line. It should be displaying at most 80% remaining. Note the attached file shows a long test after 50 / 200 minutes. Similar debian reports indicates it may be related to ahci and that the tests run normally under the standalone seatools freedos-based smart tests. Notice that the test still says "90% remaining"
Version-Release number of selected component (if applicable): The hang is at least somewhat drive-specific since 3 older Seagate drives complete their tests in the expected 1-5 hours. I hope you guys can give me some more information because else, I will have to go back again.Smartctl -a /dev/sda output ater a long test was run for over 50 minutesĪ long (full) test run with "smartctl -t long /dev/sda" on a Seagate 7200.12 ST31000528AS CC34 hangs showing 90% of the test remaining, even after 24 hours. So I went back to the shop and I got a new one, but after I connected it, I got the exact same error. The chkdsk command didn't work and after running the seatools program from seagate, it said it couldn't repair it. Please see the 'dmraid' documentationįailed to sync device /dev/sda1: Input/output errorįailed to close volume /dev/sda1: Input/output error It and mount a different device under the /dev/mapper/ directory, (e.g. Important! If the device is a SoftRAID/FakeRAID then first activate In the first case run chkdsk /f on Windows
NTFS is either inconsistent, or there is a hardware fault, or it's a Code: Select all Error mounting: mount exited with exit code 13: ntfs_attr_pread_i: ntfs_pread failed: Input/output errorįailed to read NTFS $Bitmap: Input/output error
0 kommentar(er)
